Mount in Any Direction on Variety of Surfaces
Hang Flex, MC, AC and HCF cables any which way with our one-piece galvanized SMC series steel cable hangers. They mount on a variety of surfaces in any
Available in three sizes, our SMC hangers are Listed to support and secure 14/2 to 10/4 cables – as required by NEC 300-30.
for up to four cables
They are the best and most economical hangers in the industry to meet the requirements of NEC 300.4(E) – specifically the installation of flexible metal jacketed cable under corrugated
metal roof decking. The outer surface of cables other than RIGID and IMC must be at least 1-1/2" (38 mm) from the surface of the roof decking. Our SMC hangers exceed this requirement, keeping cable away from the surface by more than 2".
SMC8 holds up to eight cables.
SMC4 holds up to four.
SMC4F mounts flat, holding up to four cables on one side of the hanger.
• Cost less than cable tray
• Secure installation with a screwdriver
• Mount SMC in any direction. Suspend. Twist. Or stack.
Arlington’s steel SMC MC Cable hangers meet the
requirements of NEC 300.4(E) for installing MC or AC metal jacketed cables under corrugated metal roof decking.
SMC8 SMC4F SMC4
The outer surface of cable must be 1-1/2" from the underside of the decking. Our SMC Hangers exceed this requirement!
SMC8, SMC4, SMC4F
• Secure cables independently without bundling
• Attach with beam clamp, threaded rod or screws
• Meet NEC 2020 300.4(E), 320.30, 320.30(A), 330.30, 330.30(C), 348.30(A) and 348.30(B)
Use our SMC steel hangers in place of cable tray for a cost-effective installation.
Install with a screwdriver
Bend a tab over the cable to lock it firmly in place.
SMC4, SMC4F and SMC8
screw-mount on metal or wood studs... concrete block walls... or ceilings
Supports and secures up to eight 3/8" Flex and/or 14/2 to 10/4 metal jacketed cables per the NEC
4, on one side